Sale & Clearance
Deal Of The Week
Male Stainless Steel Quick Disconnect w/ FPT
In Stock
Delivers to ( change ) by as part of our Fast & Free Shipping.
Faster Shipping Available. Details.
60 day no hassle return policy. Details

When used in conjunction with the female QD these quick disconnects seal up completely regardless of the liquids direction of flow, while remaining simple and easy to use. This will work with any of our H503 and H507 series of quick disconnects. However, it does not work in conjunction with any of our plastic or brass quick disconnects. These feature a 1/2" Female National Pipe Thread on the ends for easy connectivity to almost anything.
The quick disconnect will hold pressure for typical brewing applications when moving liquids at 60psi or less. 1/2" ID. Gasket temperature range is -40° to 250° F. Open port, does not have shut-off.
We designed the original stainless QD's for the brewing industry over 10 years ago. The same manufacturer has been machining them for us ever since. The design has certainly been copied but not with consistent quality. That is why our Stainless QD fittings have a near unanimous 5 star review with retail customers.
Please Note: This product will NOT work with our Brass or Plastic Quick Disconnects.
Item # H503D
Shipping Eligible for Free Shipping Program
Availability California - In Stock
Pennsylvania - In Stock
Weight 0.25LBS
Size1/2 in.
MaterialStainless Steel
UseQuick Disconnect
Community Q&A

Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 2 questions Browse 2 questions and 4 answers
Why did you choose this?
MoreFlavor Store
Adding chugger pump to quick disconnect setup.
George B on Jan 15, 2018
Adding chugger pump to quick disconnect setup.
George B on Jan 15, 2018
I recently purchased this quick disconnect to connect to my Blichmann HopRocket, to the 1/2" MPT. However, the threading only goes on about halfway before it can't go anymore, leaving about half the threads on the MPT exposed (not fully on). This causes a small leak when operating the HopRocket. My question is, why wouldn't the threading on this quick disconnect fully fit onto the standard 1/2" MPT on the HopRocket? I used teflon tape and tightened until snug but not overly tight. Thanks.
Jeffrey Baker on Jan 11, 2018
BEST ANSWER: I'm not an expert with the terminology, but I have a lot of the SS quick connects throughout my system. I haven't had any issue with leaks. I'd try to tighten it beyond snug. I think the NPT (National Pipe Thread gradually increases in diameter to allow for a very tight fit).

4.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
High quality QD
I've used plastic and camlocks and these are the highest quality and easiest to use. I am happy that morebeer stocks this particular fitting so I can put it on my hop rocket.
May 5, 2015