March Pump - Polysulfone 230V

H375

March Pump - Polysulfone 230V

H375

$199.99 & FREE Shipping on orders over $59.

QUANTITY

In Stock

Delivers to ( change ) by as part of our Fast & Free Shipping.
Faster Shipping Available. Details.

Returns

60 day no hassle return policy. Details

Description

Same polysulfone pump housing as our H315, but featuring a 230V motor for customers from Europe, Australia, New Zealand, etc. Does not come with the 6' cord or the built-in base. Has a 3' cord to which you will need to wire the appropriate plug.

Note: When using silicone tubing, we recommending using a slighlty larger barb than the I.D. of the tubing. This is because silicone tubing tends to have greater pliability than most tubing. For example, when using 1/2" silicone tubing, we recommend our 5/8" barb (H620), to help ensure a better seal!

California Recipients: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Item #	H375
Shipping	Eligible for Free Shipping Program
Availability	California - In Stock Pennsylvania - Out Of Stock
Weight	6 LBS

Community Q&A

Questions that need answers | My Posts

Start typing your question and we'll check if it was already asked and answered. Learn More

No questions have been asked about this item. Be the first!

Reviews

Review More Purchases | My Posts

4.0 / 5.0

2 Reviews

5 Stars

4 Stars

3 Stars

2 Stars

1 Star

Rated 4 out of 5

Back-Saver!

Definitely cuts down on lifting/lugging large amounts of (normally hot) water/wort/etc.

This pump is pretty tough. I have dry-run the pump multiple times and it keeps on kicking!

It does tend to plug with excessive amounts of hop material in the kettle, especially with whole hops. However, it is very easy to disassemble and clean if needed. I normally just CIP with PBW and hot water after brewday is over.

Was this review helpful? Yes (0) No (0)
Flag as Inappropriate

May 15, 2013

Kyle Kohlmorgen

Was this review helpful? Yes (0) No (0)
Flag as Inappropriate

Rated 4 out of 5

Great pump but can have problems priming without a bleed valve.

Great pump, really good flow rate and can pump up pretty high when there isn't much restriction on the intake side - so place the pump near where you are going to pump from with a short hose if possible or even directly on the tank for the best flow rate if you really need to push it.

The only downsides are that the o-ring inside is very thin and will expand and not fit anymore if you take it apart a few times to inspect/clean, and this pump can have problems priming so it's best to have a bleed valve on the pump-out side - aim it downwards from the pump port to make it easy for liquid to just drain downwards and not have to travel up and over anything, then your pump will prime when you just open the bleed valve. Makes it easy to take a test sample too!

Was this review helpful? Yes (0) No (0)
Flag as Inappropriate

April 30, 2013

Ryan M

Was this review helpful? Yes (0) No (0)
Flag as Inappropriate

CONNECT
NEWSLETTER

Sign up to receive exclusive deals, tips and tricks, special coupons and much more ...